Anchor The Fuse TM Wedge In & Strain Relief Notch
Hand fired shows? No more shell leaders falling down inside the gun! Position mortars with the notch slightly to the side, lower your shell into the mortar, locate the quickmatch shell leader into the tapered notch and wedge it in. When pulled to the very bottom of the notch, finale chains perform more reliably. Additionally, by placing the bare leader (with its safety cap removed), of the shell from the bordering mortar into this notch from the outside towards the inside, successive shell ignition can be achieved. These mortars containing bare match shell leaders must be covered to prevent premature ignition.
Electric fired shows? No more match lead wires attached to shells firing that yank unfired connections from the circuit! Lower your shell to the bottom of the mortar with match attached. Loop a circle in the wire lead, insert the loop in the tapered notch, pull it to the side and give it a tug. The lead wires won't jump out of the hook socket. Shells leave the mortar, lead wires stay hooked at the mortar mouth. After the display, leads are easily removed by yanking them to the left.
Back
